FISHINGCRITICFree knot cards

KNOT GUIDE

How to tie a palomar knot

A doubled-line attachment for a hook or lure. Leave enough loop to pass the entire hook or lure through it.

FishingCritic is research-led, using maker data and published sources. We have no hands-on test results for this edition.

Where should you use it?

Line: mono, fluoro, braid. Use: hook, lure. The standing line goes to the reel; the tag is the free end. A bight is a folded section of line.

Animated Knots: Palomar

Standing line

Tag end or working bight

A white gap at a crossing shows the strand passing over.

How do you tie it step by step?

  1. Step 1: Double about 6 inches of line. Pass the bight through the hook eye; keep both strands parallel.
    01 Double about 6 inches of line. Pass the bight through the hook eye; keep both strands parallel.
  2. Step 2: Make a loose overhand knot with the doubled bight around the two standing strands. Leave the hook hanging below.
    02 Make a loose overhand knot with the doubled bight around the two standing strands. Leave the hook hanging below.
  3. Step 3: Open the bight and pass it completely over the hook or lure. Bring the loop above the eye.
    03 Open the bight and pass it completely over the hook or lure. Bring the loop above the eye.
  4. Step 4: Wet the line. Draw both ends evenly until the knot seats at the eye. Check that no strand crossed; trim the tag.
    04 Wet the line. Draw both ends evenly until the knot seats at the eye. Check that no strand crossed; trim the tag.

What should you check before casting?

The bight must pass over the whole hook. A crossed doubled strand or a loop trapped on the shank is not a seated Palomar.

Wet the line before tightening. Pull firmly on the finished connection, inspect the wraps, and retie if they overlap or the line is damaged. No knot-strength percentage is claimed.

Where do these facts come from?

The links identify source URLs and check dates. The source data records access limits.